• If you are going to cut a 24 inch rod below 12 inches please call or email me as you will need to purchase a special amp to boost the signal.

  • PVC Rod for Metal Tanks. View of 1" pipe thread fitting. Bottom end is sealed or can be shipped open ended and you cut and seal with simple instructions.


Reading is through the PVC pipe. This is a non fouling rod in waste tanks.

To right 5 Hole SAE to 1" flange for our water & waste rods

The flange can be purchased for $19.95 for Straight Rods

Click on link below for Manuals and Fliers

Profile Series 8-Tank Monitor Firmware R3.1a
Legacy 6.0 & 7.0 Cut out Sheet
Solo Manual
Solo Cut Out Sheet
External Sensor Manual
Internal PVC Rod Manual
PVC Cutting Sheet
SAE 1NPT Drawing
Gauge Float Hook Up
Solo Flyer
Sensor Flyer
Legacy Flyer
EZ Profile flyer
Hunter Guide, switch from Ultra 8 to our legacy
Good Old Boat Article
Houseboat Article
Hunter 1999 Legacy Installation


REFUND POLICY
 
NO REFUNDS ON CUSTOM ORDERS:
i.e. Finished Rods, Custom Panels, Logo's, etc. 

20% restocking charge on all returns.  Merchandise must be in NEW condition and have not been installed. Must have RA number

Shipping and handling to customer at our cost is also deducted from return even though customer may not have been charged.

Defective Merchandise will be repaired or replaced per Warranty agreement in OWNERS MANUAL.

1 Tank Solo Panel No Alert No sensor Kit

Panel size 2.0" H X 3.5"
Cut out size 1.5" H X 2.5/8" W

Profile Solo Display Module For Under-Counter Installation

This version of our popular Solo tank monitor and display is functionally identical to the Solo display panels described above, it is just housed in a sturdy ABS enclosure for easy under-counter or under-cabinet installation. 

Of all our tank monitors and displays, this is by far the easiest to install as there is no panel cutout to make. To secure it you just need 4 screws. 

Additionally, the Empty and Full calibration buttons have been hidden away inside of this units housing thereby preventing inadvertent re-calibration or re-configuration by children or curious guests. 


Basic Features:


  • Runs our simplified EZ-Profile algorithm.
  • Monitors one tank.
  • Tank level displayed in quarters.
  • Optional autonomous tank monitoring.
  • Optional tank high/low alert light.
  • Compatible with all of our capacitive sensors, most capacitive sensors
  • manufactured by other companies, & 240-33 Ohm float sensors.
  • Push button empty/full calibration.
  • Overall module dimensions: 4 5/16" wide (measured at the flange)
  • by 1 5/8" tall by 2 1/2" deep
  • Visible face dimensions: 3 1/8" wide by 1 5/8" tall.

1 Tank Solo Panel for Waste tank with Full alert no sensor kit

Panel size 2.0" H X 3.5" W
Cut out size 1.5" H X 2.5/8" W

Legacy 6.0 & 7.0 Version 3.1a
Legacy panels come with panel only, no sensors

Sensor Kit for Composite Tanks, Water & Waste

We also have a sensor repair kit, it is on the order page

When you push the up or down arrow you will get the screen below.

Cut out for 6.0:  5.1/4 Wide by 3 1/8 high
Cut out for 7.0:  5 1/4 Wide by 3 1/8 high

Monitoring Systems


Manuals  & Fliers at Bottom of Page

If you just want to take advantage of all the features of our panel remember our panel works with just about every sensor on the market today.

WE MANUFACTURE ALL OUR OWN PRODUCTS IN HOUSE
NEW PROVIDENCE MARINE / FERRIELLO SALES LLC


Profile Series 8-Tank Monitor Firmware R3.1a SHOWS ALL TANKS

Under Counter Mount  No sensor kit 

Empty or Full Alert

1 Tank Solo Panel for Fresh Water tank with Empty Alert no sensor kit

Panel size 2.0" H X 3.5" W
Cut out size 1.5" H X 2.5/8" W

MONITORING SYSTEMS FOR MARINE & RV APPLICATIONS,
WATER, WASTE AND FUELTANKS

​Solo Profile Single Tank Monitor and Legacy Profile 8 Tank Monitors
For Water Tanks, Waste Tanks and our panels will read most every sensor on the market
None Fouling Sensors for use on the outside of Composite Tanks and None Fouling Rods

​that go inside of your Metal Tanks


We also have 90 degree None fouling rods that go in the side of your tanks

WE MANUFACTURE ALL OUR OWN PRODUCTS IN THE USA

FERRIELLO SALES LLC